DTF Instructions (Decals for Fabric)

Preparation

Check Your Garment: Ensure the garment is clean and free of lint or debris. Use a lint roller if needed.

Prepare Your Workspace: Set up your heat press or iron in a clean, well-ventilated area.

Heat Press Settings

COTTON

150 Degrees Celsius, 10seconds, High pressure, 2nd press 10 seconds

POLY

120-130 Degrees Celsius, 8 seconds, MEDIUM/HIGH PRESSURE, 2nd press 6 seconds

POLY/BLENDS

130-140, 10 seconds Degrees Celsius, MEDIUM/HIGH PRESSURE, 2nd press 10 seconds

Application Process

Position the Design: Place the DTF transfer face upon the garment. Ensure it is centered and aligned correctly.

Protect the Design: Cover the transfer film with a Teflon sheet or parchment paper to prevent sticking or damage.

Press the Design:

Heat press: Close the press and apply pressure.

Iron: Apply firm, even pressure across the transfer, making sure to cover all areas without moving the iron around.

INSTANT HOT or Cold Peel: Either peel straight away or allow the transfer to cool completely before peeling off the film. This is known as a cold peel.

Peel the Film: Slowly and carefully peel away the transfer film, ensuring the design stays adhered to the garment.

Repress the Design: For added durability, place a Teflon sheet or parchment paper over the design and press again for 5–10 seconds.

Ensure consistent pressure and avoid overheating, as this can affect the transfer's adhesion.

Aftercare

Wait at least 24 hours before washing.

Wash garments inside out in cold water on a gentle cycle.

Avoid bleach and fabric softeners.

Do not tumble dry.

Do not iron directly over the design.